QuinLED Data Booster

The perfect add on for boosting the data signal of your LED setup!

Once the data signal cable gets longer than ~3m/10ft LEDs can start to flicker or act irractic. QuinLED Data Booster can clean and boost your data signal to your setup to get this under control. 

QuinLED Data Booster adds the following features to your setup to manage and overcome these  limitations.

• Supports power in/out of 5v – 48v
  • High current carrying board design
• Power injection points with M3 bolt or solder
  • Use direct solder to pad/hole
  • Use crimped fork or Ring connector With M3 Screw/Nut
• Re-broadcast Data Signal
  • Onboard level-shifter to take in signal, boost and send it out again
  • “Cleans up” data signals to allow long distances between LED Strips/Pucks
• Data Signal cable conditioner
  • Switch selectable 33Ω and 249Ω resistor output
• Clean Labelling allowing quick and easy connections without mistakes.

Product contents:
QuinLED Data Booster board
Crimp fork connectors
Screws

Additional information / About Quinled

Quinled offers a range of DIY and ready build products than run open source firmware and unlocked hardware. Community support can be found on the community discord server, multiple blogs and the Youtube channel.